Ürün No. 64005
Funcosil AS
siloksan/akrilat esaslı, renk yoğunlaştırıcı ve hafif güçlendirici etkiye sahip hidrofobik emprenye
Ürün varyantları
İndirilebilir Dökümanlar
Teknik Özellikler
Uygulama Alanları
- Protection of facades against driving rain
- Reduces susceptibility to dirt and green discolouration
- Faded, porous, mineral building materials such as brick, clinker and concrete blocks
Özellikler
- Colour intensifying
- Slight strengthening action
- Repels water
- Enables water vapour diffusion
- Good penetration capacity
- UV-resistant
- Alkali-resistant
- Excellent long-term effect
- Substrate requirements: The substrate must be clean, dust-free and dry.
- Preparations: Any construction defects such as cracks, cracked joints, defective connections, rising damp and hygroscopic moisture must be remedied in advance. Perform any necessary cleaning gently, e.g. by spraying with cold or warm water or by steam-cleaning; use rotec soft whirl jet technology or Remmers cleaning products (e.g. Traffic Film Remover (0671), Clean FP (0666), Clean AC (0672), Combi WR (0675)) on tough stains.
- Apply the primer abundantly by flow coating without pressure (avoid misting), so that a 30 - 50 cm long liquid film flows down the surface. Apply on one section at a time, moving from top to bottom, and immediately go over with a large brush. Repeat the application several (at least two) times (wet on damp) until no further material is absorbed by the substrate. On surfaces where spray application is not possible, apply using a well-saturated brush.
- Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product. Protect freshly treated surfaces from driving rain, wind, sunlight and condensation. Remove any excess impregnation agent within 1 hour using V 101 thinner.
- Solvent-resistant low-pressure, conveying and spraying equipment, liquid pump, paintbrush, flat brush and lamb's wool roller
- Tools must be clean and dry. After use and before prolonged interruptions of work clean tools with Thinner V 101.
- If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 24 months. Use the contents of open containers as quickly as possible.
- Old brick: min. 0.5-1.0 l/m² Old clinker: min. 0.2-0.5 l/m² Exposed aggregate concrete: min. 0.25 l/m² Sand-lime brick, interior: min. 0.5 l/m²
- Apply to a large enough trial surface (1-2 m²) to determine the precise amount of impregnation agent required.
- Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately. The relevant test certificates must be observed when planning and carrying out work. Water must not be allowed to penetrate behind the hydrophobized zone. Not suitable for materials that are sensitive to solvents, such as polystyrene or bitumen. The level of absorption is crucial for the impregnation agent to work at its best. This depends on the respective pore volume and moisture content of the building material. Carry out a quantitative analysis of aggressive salts if there are any salts present that could damage building materials. High concentrations of harmful salts can cause major structural damage that impregnation cannot prevent. Testing effectiveness:The water absorption of mineral building materials can be determined using the Funcosil Test Tube developed by Professor Karsten (Funcosil Facade Testing Kit, article no. 4954).Testing can only be carried out at the earliest 6 weeks after application. A test of effectiveness needs to be carried out on carbonaceous natural stone. Always set up a trial area/trial areas first.
- Dispose of contents/container in accordance with local/regional/national/international regulations.