Ürün No. 40525
WP DS
Yeni yapılar için rijit mineral su yalıtım şerbeti
Ürün varyantları
İndirilebilir Dökümanlar
Broşürler
Teknik Özellikler
Uygulama Alanları
- Waterproofing of reservoirs against inside water pressure
- Damp proofing for below ground waterproofing measures
- On mineral substrates
Özellikler
- Water pressure tight
- Very good adhesion to the substrate
- Enables water vapour diffusion
- Substrate requirements: Clean, dust-free and capable of supporting a load.
- Preparations: In the floor-wall connection remove screed for a width of approx. 20 cm. Break off or chamfer corners and edges. Coves must be rounded out. W1-E: seal pipe penetrations by using the product to form a cove around them. Primer Prime absorbent mineral substrates with Kiesol MB.
- Immediately after mixing, apply the material making sure the entire surface is covered. Damp proofing Apply one layer on the previously prepared surface. Application of render Apply the waterproofing as additional grout layer and then throw on SP Prep (Preparatory Mortar) wet-on-wet.
- Do not use in direct sunlight. The maximum total wet coat thickness must not exceed 5 mm. Protect the fresh waterproofing layer from rain, direct sunlight, frost and condensation water. Once dry, protect from mechanical damage. Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar. Please contact Remmers Technical Service (phone +49 5432 83900) before applying with machine processing.
- Mixing equipment, wide brush, grouting broom
- Clean tools with water while the material is still fresh.
- If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
- Approx. 1.6 kg/m²/mm layer thickness
- Layer thicknesses and application rates Min. layer thickness (mm) Application rate - fresh mortar (kg/m²) Application rate - powder (kg/m²) Yield 25 kg (m²) (paper bag) ≥ 3.0
- The mixing water must be of drinking water quality. May contain traces of pyrite (iron sulphide). Low chromate content in accordance with Directive 2003/53/EC. Always set up a trial area/trial areas first. The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity. Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately. The relevant test certificates must be observed when planning and carrying out work. Special agreements and certificates of suitability can be downloaded online at www.remmers.com.
- Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
- For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.